Dutch Boy® Tex-a-crete™ Primer 3110

Dutch Boy® Tex-a-crete™ Primer is a concrete primer for plain or textured Tex-a-crete™ finishes. It is an acrylic solvent-based coating that forms a seamless, non-porous, watertight film that repels water and prevents seepage. 

Share :

Share on Facebook Share on Twitter Share on Google Plus

PACKAGING: 
4-Liters and 16-Liters

FINISH: 
Flat

APPLICATION: 
By brush, roller, or spray 

PRACTICAL COVERAGE: 
25 to 30 square meters

DRY THROUGH: 
To touch: 30 minutes
To recoat: 2 hours

THINNING SOLVENT: 
Dutch Boy® Tex-a-crete™ Reducer 3000

TINTING: 
Not applicable

CLEAN UP  SOLVENT: 
Dutch Boy® Tex-a-crete™ Reducer 3000

SURFACE PREPARATION: 
New Concrete
New concrete should dry for 14-28 days under normal weather conditions before painting. Surface to be painted should be clean and dry, free from oil, grease, dust, dirt, contaminants, and all loose grit and mortar. 

Wooden Surfaces
Surface to be painted should be clean and dry, free from dust, dirt, and other foreign matter. Hammer all nails deep enough to apply putty. Sand rough wood until smooth and then dust off before painting.

Repainting
Scrape off all loose, scaling, flaking, and peeling paint manually or by using a paint and varnish remover. Wash surfaces clean and completely remove any residue. Let it dry. 

Use a surface conditioner in case the surface to be painted is chalky. In case of mildew infestation, treat with a bleach solution (1:3, laundry bleach to water, respectively) by swabbing or brushing. To ensure proper treatment, let stand for 24 hours before washing off residue. Let dry.

For repainting other surfaces such as wood, follow the first step then apply the appropriate primer before recoating.

PAINTING SCHEDULE:
Plain Finish

  1. Prime bare substrate with Dutch Boy® Tex-a-crete™ Primer 3110
  2. Putty minor surface imperfections with Dutch Boy® Tex-a-crete™ Cast 3211
  3. Spot prime puttied areas with Dutch Boy® Tex-a-crete™ Primer 3110
  4. Finish with at least 2 coats of Dutch Boy® Tex-a-crete™ Topcoat to desired sheen

Textured Finish

  1. Prime bare substrate with Dutch Boy® Tex-a-crete™ Primer 3110
  2. Spray Dutch Boy® Tex-a-crete™ Cast 3211 using a mortar gun. For a flattened texture, press Tex-a-crete™ Cast using a plain wooden roller within 10 to 15 minutes after spraying
  3. Finish with at least 2 coats of Dutch Boy® Tex-a-crete™ Topcoat to desired sheen.

Note: Wet wooden roller with Dutch Boy® Tex-a-crete™ Reducer 3000 to prevent the roller from sticking to the cast.